!
monitor session 1 source vlan 10
monitor session 1 destination interface Gi3/0/14 , Gi3/0/16 - 17
The above is valid on a Cisco switch.
how can I match that on a Meraki MS355-24X?
I can see how to mirror a port, but not a whole VLAN.
Solved! Go to solution.
Are you talking about SPAN and RSPAN? Meraki dosen't have a CLI but you can run a packet capture on a specific port.
the monitoring is being sent to an external server on a permanent basis, hence the source and destinations on the Cisco command lines.
I'm not sure if it's possible. I know that you can send a netflow for a specific IP, but It's not you are looking for.
You cant. The source are switch port(s)
Thanks for that clarification. Some commands on Cisco are just not available on Meraki.
Hopefully if I mirror a trunk port, my customer can monitor the traffic.