VLAN - Issue

Just browsing

VLAN - Issue

VLAN 110 used as trunk for uplink ports in meraki switches

And at same time VLAN 110 if assigned to any other ports doesn't works with dhcp.

It gives apipa range only.



4 Replies 4

Can you provide a bit more information?


How did you exactly configure your uplink?

From Meraki (model?) to 3rd party switch?

Did you configure DHCP Relay, where?

A model citizen

Is the port connected to the uplink set for 110 as well?

Found this helpful? Give me some Kudos! (click on the little up-arrow below)

Yes it was . I changed the native port to some other VLAN


Now the VLAN 110 is functioning well.

Meraki Employee
Meraki Employee



It could be an issue if there is a native VLAN mismatch on the trunk ports or if the VLAN is pruned.

Just ensure the trunk port configuration is the same on both ends. 





Please hit kudos if you found this post helpful and/or click "accept as solution" if this solved your problem.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.