Meraki

Haris · ‎Feb 17 2020

VLAN 110 used as trunk for uplink ports in meraki switches

And at same time VLAN 110 if assigned to any other ports doesn't works with dhcp.

It gives apipa range only.

bvdijk71 · ‎Feb 18 2020

Can you provide a bit more information?

How did you exactly configure your uplink?

From Meraki (model?) to 3rd party switch?

Did you configure DHCP Relay, where?

Mr_IT_Guy · ‎Feb 18 2020

Is the port connected to the uplink set for 110 as well?

Found this helpful? Give me some Kudos! (click on the little up-arrow below)

Haris · ‎Feb 18 2020

Yes it was . I changed the native port to some other VLAN

Now the VLAN 110 is functioning well.

DensyoV · ‎Feb 18 2020

Hi,

It could be an issue if there is a native VLAN mismatch on the trunk ports or if the VLAN is pruned.

Just ensure the trunk port configuration is the same on both ends.

Thanks,

Please hit kudos if you found this post helpful and/or click "accept as solution" if this solved your problem.

Community