Storm Control question

Solved
redsector
Head in the Cloud

Storm Control question

Hi,

 

I can set a Storm Control on Switch > Switch Settings and the rules.

I also can switch on Storm Control on the switchports MS210, MS225 etc. (enabled / disabled).

Does anybody know if there is an relationship?

Does the rules only work when I switch on the Storm Control on the ports?

 

Thank you.

1 Accepted Solution
BrechtSchamp
Kind of a big deal

When you add at least one rule in the "Switch settings" rules, then the per port enable/disable option becomes available. Basically it allows you to make exceptions to the general storm control rules for specific ports.

View solution in original post

5 Replies 5
MarcP
Kind of a big deal

can´t see it on MS120 :S

 

Model is not lsited here... Can you really see that for the MS120 on switch ports ?

https://documentation.meraki.com/MS/Other_Topics/Storm_Control_for_MS

BrechtSchamp
Kind of a big deal


@MarcP wrote:

can´t see it on MS120 :S

 

Model is not lsited here... Can you really see that for the MS120 on switch ports ?

https://documentation.meraki.com/MS/Other_Topics/Storm_Control_for_MS


It isn't supported on the MS120. See the datasheet:

MS210MS210

 

MS120MS120

BrechtSchamp
Kind of a big deal

When you add at least one rule in the "Switch settings" rules, then the per port enable/disable option becomes available. Basically it allows you to make exceptions to the general storm control rules for specific ports.

Nash
Kind of a big deal

It's worth noting that there's a basic level of storm control present on all Meraki switches. The configurable version is only available on firmware versions 10.0 and higher, but not available on the 120 line.

 

https://documentation.meraki.com/MS/Other_Topics/Storm_Control_for_MS

redsector
Head in the Cloud

 

BrechtSchamp was right.
 
 

I checked it out:

 

Based on MS11.22 firmware; MS225, MS210 switches:

 

First you have to enable Storm Control  in "switch" -> "switch settings" by adding a rule.

Then you have an additional "Storm Control" setting in the switchports (not on the MS120 and MS220 switches!)

 

best regards.

Get notified when there are additional replies to this discussion.