Storm Control question

[redsector]

Hi,

I can set a Storm Control on Switch > Switch Settings and the rules.

I also can switch on Storm Control on the switchports MS210, MS225 etc. (enabled / disabled).

Does anybody know if there is an relationship?

Does the rules only work when I switch on the Storm Control on the ports?

Thank you.

[MarcP]

can´t see it on MS120 :S

Model is not lsited here... Can you really see that for the MS120 on switch ports ?

https://documentation.meraki.com/MS/Other_Topics/Storm_Control_for_MS

[BrechtSchamp]

---

@MarcP wrote:

can´t see it on MS120 :S

Model is not lsited here... Can you really see that for the MS120 on switch ports ?

https://documentation.meraki.com/MS/Other_Topics/Storm_Control_for_MS

---

It isn't supported on the MS120. See the datasheet:

MS210

MS120

[BrechtSchamp · Accepted solution]

When you add at least one rule in the "Switch settings" rules, then the per port enable/disable option becomes available. Basically it allows you to make exceptions to the general storm control rules for specific ports.

[Nash]

It's worth noting that there's a basic level of storm control present on all Meraki switches. The configurable version is only available on firmware versions 10.0 and higher, but not available on the 120 line.

https://documentation.meraki.com/MS/Other_Topics/Storm_Control_for_MS

[redsector]

BrechtSchamp was right.

I checked it out:

Based on MS11.22 firmware; MS225, MS210 switches:

First you have to enable Storm Control  in "switch" -> "switch settings" by adding a rule.

Then you have an additional "Storm Control" setting in the switchports (not on the MS120 and MS220 switches!)

best regards.