- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
STP root bridge page for configuration
Hi ,
as per the documentation, i'm supposed to configure a root priority number on the 'switches/stacks' location.
My dashboard has 'Switch Stacks', however I have no stacks and therefore no switches show up on this page.
How do I set my root to be the core switch in this case?
- Labels:
-
Other
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Click on the link "Set the bridge priority for another switch or stack" under switches/stacks location.
Then click on "chose Switches" --> Select the Switch --> Assign the bridge priority --> Save
Please mark as solution the useful replies.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To add to this reply, here is the documentation with images
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
THanks, I read this before posting.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is all i see on this page. Its not clear, but I guess I click on ádd one' when I'm not configuring stacks on the network and then choose a single switch and change the priority?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You should be looking here:
I just did it with a non-stacked switch, and it worked fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks, When I hover on my Switch tab under a created network I get less options:
Switches
Switch ports
Switch Stacks
Dhcp servers/arp
Routing and dhcp
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sounds like you are not an admin for that network?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hmm, good point. I checked and out of none, read only and full. I have full
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is very weird, are you sure your dashboard is loading properly?
Do you see the status of your switches? What models do you use?
For a test - try maybe to hand craft the url to that section:
Go to the Monitor -> Switches part
replace the end of the url (so this part /manage/switches/*)
with /manage/configure/switch_settings
(https://nnnn.meraki.com/xxxxxx/n/zzzzzz/manage/configure/switch_settings)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That was a good idea, I did switch_settings at the end, and it takes me to
general
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It doesn't sound like you are a full admin. Perhaps you have read-only access?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All, its due to using a Template. If I go into the template I can see the option. BUT, i don't want to apply this change to all my networks.
So i'm asking support how I can target each switch across all my networks to receive the change in priority only.
I have a suspicion i'll have to unassign from the template.