STP - Stopped receiving BPDUs with loop guard enabled

[Sweemz]

Hi All,

I hope we are well.

I’ve recently inherited a Cisco Meraki network following an acquisition and have noticed some alerts.

Edit - Added Network Topology/Switch overview (below)

Toplogy

Switch Overview

The network Consists of:

2 x MX105 in HA config.

5 x MS130-48P 

4 x CW9166I

I've documented the network as best as possible.. (minus the access points) will re-review tomorrow and update asap.

Version 1

Version 2 - Since Reviewing Meraki Live Topology

- Root Ports mislabelled / corrected 

DUG00-SW01 Port 51 

DUG00-SW03 Port 50

The affected ports seem to be alternate uplink ports, so the network is still operational. I’d just like to understand the issue and get the network’s RAG status back to healthy.

Any thoughts on the best place to start troubleshooting?

Thanks in advance - let me know if you need more information!

[RWelch]

I realize you mentioned inheriting this network but the device health notice indicates SW01 and SW03 error notices yet the lower images you share indicate SW04 and the port descriptions don’t seem to jive.  Seems like something doesn't quite add up.

[RWelch]

Can you share a screen capture of the topology from the meraki dashboard to see what that shows....I'm curious to see if that might reveal more insight.  Not meant as critical at / toward you....just tried to understand the above and I looked at it like 10 times.

[IvanJukic]

Hi @Sweemz ,

Not sure I follow the Topology Diagram either. Port 52 is directly connected to the Root switch. So that would be the Root port. Port 49 & 50 would be alternate ports.

I agree with @RWelch. The Topology map in the Dashbaord is 'live". So if the Tree changes so will the map. I use it daily. Best tool to use for these kind of queries.

https://documentation.meraki.com/MS/Monitoring_and_Reporting/Network_Topology

If you can share a screenshot, that'll be helpful.

[Sweemz]

Hi @IvanJukic 

Thank you for looking into this.

2nd glance i've clearly made some mistakes with my labels 😅

Using the Network topology tool I have re-confirmed the uplinks/ports and updated my documentation to reflect the live links in the Meraki Toplogy.

[Sweemz]

Not sure why I didn't include these originally 😅 .. Thank you for looking into this btw

Toplogy

Switch Overview

[RWelch]

Not sure why 3 downlinks is needed….overkill or over engineered.  I’d personally remove the link between SW01 and SW04 then double check the other downlink/uplink port descriptions to verify they are to the right destinations.

[RWelch]

Too many redundant paths likely intended for a failover situation but the errors seem to be the redundant paths 3 downlinks.

[RaphaelL]

APs do not participate to the STP topology so that shouldn't matter