Jan 9 2024
5:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 9 2024
5:41 AM
Offline Configuration
Hi
Is there a way we can configure Meraki devices offline.
If we perform routing changes for default route in Core switch, it might lose connection to Meraki Dashboard, in that case, can we perform configuration changes offline?
Regards
3 Replies 3
Jan 9 2024
5:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 9 2024
5:47 AM
No, it's not possible. Meraki devices are managed by the Meraki Cloud.
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
Please, if this post was useful, leave your kudos and mark it as solved.
Jan 9 2024
6:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 9 2024
6:06 AM
The management vlan of the (core) switch should not use the default route of the core itself. Use a seperate layer2 vlan to the (internet router/firewall)
Jan 9 2024
6:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 9 2024
6:54 AM
Thank for response ww.
We have same vlan for Management and default route in current configuration of core switch. So, we need to change the default route pointing to SDWAN cEdges as well as Management LAN IP for core switch.

Get notified when there are additional replies to this discussion.