Observer level access - Can no longer 'see' DHCP settings/options on Switch managed VLANs

[NeilB83]

Probably can't change this but has anyone else had issues with Observer level access and the new dashboard changes? Previously you could see the DHCP settings per VLAN (DNS, options, lease time, reserved IPs etc.) on each VLAN on switches but now you can't drill down into each VLAN under Switching > Routing and DHCP.

I know this is technically a 'Configure' area but there was no harm in being able to view the settings for troubleshooting or flagging errors to those who do have admin rights to change settings.

[alemabrahao]

As far as I remember, Observe has always been view-only in areas classified as Monitor.

And Read-only can view the settings.

I think you're confusing things.

[NeilB83]

Thanks. I did check though and its observer and it definitely worked before:

https://documentation.meraki.com/Platform_Management/Dashboard_Administration/Operate_and_Maintain/M...

Roles

View all available roles for your organization or network in the "Roles" tab.

Full Access 

• (Organization scope): Highest level of access. This gives full administrative access to all networks and organization settings.

• (Network scope): Network level access gives full administrative access to selected networks.

Observer

• (Organization scope): Read-only administrative access to the organization without the ability to make any changes. 

• (Network scope): Access to most aspects of a network, including Configure sections without the ability to make any changes. 

[alemabrahao]

To be honest, this doesn't make sense, because it's describing the ready-only role.

This document seem to be wrong.