MS250 - poe port was denied power

SOLVED
akan33
Building a reputation

MS250 - poe port was denied power

I have some biometric devices connected to several MS250 switches, the connectivity bar shows green and orange intermittently displaying a message 'POE port was denied power'. I haven't found much info about it, I don't know if any of you have seen this before. Thanks!

 

my SW version is: 9.32 

1 ACCEPTED SOLUTION
PhilipDAth
Kind of a big deal
Kind of a big deal

This can occur if you have exceeded the PoE budget on the switch.  If you go:

Switches/Switches/[select switch]/Power Tab

It will show you your available budget and how much you have used.

 

Screenshot from 2018-01-10 20-02-07.png

 

Failing that, what does the event log (next tab along) for the switch show when this happens?

View solution in original post

10 REPLIES 10
PhilipDAth
Kind of a big deal
Kind of a big deal

This can occur if you have exceeded the PoE budget on the switch.  If you go:

Switches/Switches/[select switch]/Power Tab

It will show you your available budget and how much you have used.

 

Screenshot from 2018-01-10 20-02-07.png

 

Failing that, what does the event log (next tab along) for the switch show when this happens?

Also note that some devices can dynamically vary their power also.  So you might have enough power budget "right now" but not while the device is doing some particular operation.

 

If you find you are close to using your power budget up then this could be it.

This link tells you about the LED states.  Search for the word "power":

https://documentation.meraki.com/MS/Monitoring_and_Reporting/Switch_Port_View

akan33
Building a reputation

It is that yes. It is going up and down.

 

Budgeted

418 W / 370 W
 
thanks Phil for the quick response.
PhilipDAth
Kind of a big deal
Kind of a big deal

Exactly which model switch do you have?

 

MS250-24P

MS250-48LP

MS250-48FP

akan33
Building a reputation

it is a MS250-48LP

PhilipDAth
Kind of a big deal
Kind of a big deal

I see your options as:

1. Remove some of the load, and plug some of the devices directly into power (or use power injectors).

2. Upgrade to an MS250-48FP with has a 700W PoE capacity.

3. Add an MS250-24P (and potentially stack them) and and split the load between the switches. This will get you another 370W of PoE power (you need a minimum of another 48W).

akan33
Building a reputation

yes thankfully we have some more switches, we also have poe devices there but I think we can split the load. I was not aware about this limit. Thanks again Phil.  

akan33
Building a reputation

CCTVs are all working good now, but biometrics devices are still seeing this alert in the port, even if I have only a couple of them in a MS 250 it will be like that, weird. 

Mine is MS225-24P and this issue just occupied on 4 ports. Two ports connecting my APs and right now my two APs are offline.

 

Is there any other remedy to revive the ports?

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels