Hello all,
I'm getting ready to replace our old L3 Cisco Catalyst backbone switch with an MS250. We have several VLAN interfaces connected and as I am going through the old switch's IP Route table I see "Gateway of last resort is 192.168.5.1", which in fact is our firewall. I also see a static route to that IP as 0.0.0.0/0. How do I go about setting this route using the meraki dashboard? Thanks in advance, and apologies as this may be a newbie question.
Solved! Go to Solution.
Oh crap, my bad. Sorry about that. I should know better than to answer questions before I've had my first cofffee!
For an MS you have to have first enabled L3, and set up your interfaces. After that, under Switch --> Configure --> Routing and DHCP there's an "Add static route" button you can use to add your quad zero.
It's all documented here:
You can add static routes to an MX under Security appliance --> configure --> Addressing & VLANs. In the Routing section there's a table showing all the interfaces, and at the bottom of that is an "Add a static route" link. Click that, and add your default route.
Hey jdsilva, thanks for the reply! Actually, this is an MS250 switch I am referring to here.
Oh crap, my bad. Sorry about that. I should know better than to answer questions before I've had my first cofffee!
For an MS you have to have first enabled L3, and set up your interfaces. After that, under Switch --> Configure --> Routing and DHCP there's an "Add static route" button you can use to add your quad zero.
It's all documented here:
Right on! Thanks so much!