Layer 3 routed interface

Solved
ccraddock
Here to help

Layer 3 routed interface

Dear Community,

 

I am still kind of new to Meraki to please forgive my ignorance. I am trying to figure out how I can make a single switchport into a Layer 3 routed port, similar to using the "no switchport" command on a catalyst device. I have successfully created several Layer 3 routed SVI's in the Routing&DHCP section with assigned VLAN's but am not able to see how I can assign an IP address to a single switchport. Is this possible? Or do I have to create a VLAN SVI and then assign only that one switchport to that VLAN?

 

I checked under the L3 tab of the actual switchport in question but didnt see anywhere to actually assign an IP address to that individual switchport.

 

Thanks. 

1 Accepted Solution
jdsilva
Kind of a big deal

The closest you can get is to create an SVI, and then assign only a single port to that VLAN (as you suggested). 

 

Routed ports are not supported on the MS line.

View solution in original post

3 Replies 3
jdsilva
Kind of a big deal

The closest you can get is to create an SVI, and then assign only a single port to that VLAN (as you suggested). 

 

Routed ports are not supported on the MS line.

ccraddock
Here to help

@jdsilva ,

 

Thanks for the reply and the answer. I really appreciate it! 

whistleblower
Building a reputation

Hi,

 

I´d like to ask a question regarding to this! Is there anyhting else what should be considered when using this? e.g. BPDU-Filter or BPDU-Guard on the used ports on each side or other STP related topics to avoid possible Loops?

 

Is this also a Meraki suggested solution with official documentation?

Get notified when there are additional replies to this discussion.