Initial MS Setup - connecting to a Cisco traditional switch

SOLVED
MerakiMed
Getting noticed

Initial MS Setup - connecting to a Cisco traditional switch

I have an a 48 port Meraki MS and to initially set it up I will attach it to 

a Cisco 4510 switch. Is it possible to connect the Management port of the

Meraki to a 4510 switch port in access mode? Or is that Management port

just for local laptop to switch connectivity? 

1 ACCEPTED SOLUTION
Ryan_Miles
Meraki Employee
Meraki Employee

The mgmt port is just for local connection with a laptop as you mentioned if you need to give it a static in order for it to reach dashboard. Otherwise the switch will pull DHCP for its logical mgmt interface which is the common way folks deploy Meraki switches (and APs, cameras, etc).

View solution in original post

2 REPLIES 2
Ryan_Miles
Meraki Employee
Meraki Employee

The mgmt port is just for local connection with a laptop as you mentioned if you need to give it a static in order for it to reach dashboard. Otherwise the switch will pull DHCP for its logical mgmt interface which is the common way folks deploy Meraki switches (and APs, cameras, etc).

Inderdeep
Kind of a big deal
Kind of a big deal

@MerakiMed ; check out 

https://documentation.meraki.com/MS/MS_Quick_Start

Regards/Inder
Cisco IT Blogs awarded in 2020 & 2021
www.thenetworkdna.com
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels