May 7 2020
6:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 7 2020
6:16 AM
Configuring POE power statically on a Meraki switchport
Hi All,
Wanted to check if we can statically assign poe power to a Meraki Switchport like in Cisco Catalyst switch.
I wanted to check if this is possible on a MS355-48X switch.
Thanks for your answers in advance.
BR,
Soby
Solved! Go to solution.
1 Accepted Solution
May 7 2020
7:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 7 2020
7:04 AM
4 Replies 4
May 7 2020
6:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 7 2020
6:32 AM
Select switchport or in the "switch ports" tab you can select multiple and do it that way.
Enthusiast
May 7 2020
6:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 7 2020
6:42 AM
Thanks For the reply.. But what I am looking for is that if we can assign a POE power value to a port manually ie for e.g: assigning 14watts power to a port statically rather than allowing the POE device to draw the power through negotiation.
May 7 2020
7:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 7 2020
7:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 7 2020
7:11 AM
Thank you.

Get notified when there are additional replies to this discussion.