Configure LACP on switch stack using switch profile

[JohanAnderstrom]

Hi!

We are looking to use Switch profiles within a template and bind these profile to a switch stack, which is fine and works.

We also want to create a LACP aggregation between unit 1 and unit 2, this does not seem to be possible when binding a stack to a switch profile?

The only possible way to aggregate two ports is on the same switch, I am not able to aggregate one port on each unit.

Thank you in advance!

Best Regards

Johan

[PhilipDAth]

I don't think that would be possible.

You should be able to do it after you have applied the switch templates by overiding the port configuration.