Configure LACP on switch stack using switch profile

JohanAnderstrom
Comes here often

Configure LACP on switch stack using switch profile

Hi!

 

We are looking to use Switch profiles within a template and bind these profile to a switch stack, which is fine and works.

We also want to create a LACP aggregation between unit 1 and unit 2, this does not seem to be possible when binding a stack to a switch profile?

 

The only possible way to aggregate two ports is on the same switch, I am not able to aggregate one port on each unit.

 

Thank you in advance!

Best Regards

Johan

 

1 REPLY 1
PhilipDAth
Kind of a big deal
Kind of a big deal

I don't think that would be possible.

 

You should be able to do it after you have applied the switch templates by overiding the port configuration.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels