Clone a MS-120 to MS-150 Switch

[CharlieCrackle]

Am I missing something...   Upgrading a switch from MS-120 to MS 150 (same number of ports)    you can not clone between models.   ?????????    All I want to do is clone the port descriptions VLANs etc from 1 switch to another.... 

Is they a way to do this...

Even if I do manually there is not 1 page to do this easily.  It is port by port config per page 

Not looking forward to this upgrade !!!

[Gopinath_Pigili]

Check this link:

https://documentation.meraki.com/MS/Other_Topics/Switch_Cloning

[Mloraditch · Accepted solution]

You are correct, cloning only supports same model cloning.

You would need to use the API to do this otherwise in a non manual way:
https://developer.cisco.com/meraki/api-v1/get-device-switch-ports/
https://developer.cisco.com/meraki/api-v1/update-device-switch-port/

There are a couple of other calls in this category on the documentation link above that could also help.

[CharlieCrackle]

Cisco please add to the wish list to be able to copy between models   even a copy from a 24 to 48 should be supported.. (just the bottom 24 ports) 

[cmr]

@CharlieCrackle I'd argue a 24-48 should copy 1->25 etc. as the 24 ports are on the right hand side where 25-48 are on the 48 port model, but anything would be nice!