After factory reset of Meraki MS120-24 equipment

[meraki222]

I have a question about not being able to access the 1.1.1.100 web page after factory resetting the device.

[rwiesmann]

I guess you followed the information out of this document...if not check it out

https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Me...

You also can use the dedicated managmentport without the need to set the ip statically.

what type of switch do you have?

[PhilipDAth]

Did you plug into the management port?

[meraki222]

I connected it to the UTP port in front of the device, not the management port.