Meraki Community

Dunky

On the Cameras>Cameras screen is anyone else getting the Firmware version field showing as "Not running configured version" for MV52's? Al the other MV models I have seem fine, its just the MV52's.

Noticed it on 5.0.2 and it persists on 6.0.2

If you go to the Network tab for the camera though it is correct:

Ryan_Miles

It's an open bug. If you want to open a Support case they can attach your report of the issue to the parent case. This will allow for updates to you/your case when there are any.

Ryan / SE - Networking

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

View solution in original post

Ryan_Miles

It's an open bug. If you want to open a Support case they can attach your report of the issue to the parent case. This will allow for updates to you/your case when there are any.

Ryan / SE - Networking

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

Dunky

Thanks Ryan, I had guessed as much but good to have it confirmed.