Meraki Camera - MV22-HW don't work in wireless network

[BFrança]

Hello Cisco Meraki Community. 

I have a problem.
I trying connected the meraki camera in wireless network but don't work.
In meraki dashboard appeared all information the wireless lan from my office but when I remove the Ethernet cable the camera it does not authenticate to the dashboard again. 

Does anyone know what may be or have had this problem?

Thank you advance. 

[NolanHerring]

When you remove the ethernet cable, does the camera still have power? Assuming your obtaining power for the camera from a non-poe source? If so, are you certain your password is accurate for the wireless network you are attempting to associate to?

[kYutobi]

When you boot the camera does the flashing light indicate it's looking for a WIFI network? As @NolanHerring it must have power if it is not plugged into a POE port.

[BFrança · Accepted solution]

Hi,

Thanks for the answers.

Yes, the camera is powered by a power injector and the credentials are correct.
Magically she authenticated herself after 12 hours.

I will take the case as concluded.

I appreciate the community collaboration.

Have a great weekend.

[NolanHerring]

In that case your best bet is to probably just perform a hardware reset on the device to 'shake it loose' from any issues it might have. Take care!