MV52 802.3at power requirements

jbright
A model citizen

MV52 802.3at power requirements

I installed some of the new MV52 cameras over the last couple of days and they work great.

They really do need more than 15.4 watts of PoE power. And it's not even cold enough yet

to run their heaters. We may get to see that later this week here in Oklahoma.

 

Camera power drawCamera power draw

1 Reply 1
MerakiDave
Meraki Employee
Meraki Employee

@jbright  Agreed, like the 72/72X they do want/need AT power at boot (regardless of temperature) for the on-board chassis heater element.  To some extent, the camera itself can almost act like its own heater but only up to a point of course.  I'm closer to the east coast in the NJ/NYC area and have seen a few heater events hit the event log for mine, right around the freezing mark as expected. 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.