cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

MV-72 flashing blue light on boot.

Highlighted
Conversationalist

MV-72 flashing blue light on boot.

Hello;

 I have a MV-72 that I am trying to install with an 802.3AT POE injector. For some reason, the MV boots into a blue flashing light, which according to the installation manual says it is looking for a wireless connection. I tried it into different ports on the switch it is connected to (also other cameras are connected), but no luck.

 

Any Ideas?  Thanks in advance

 

 

6 REPLIES 6
Kind of a big deal

Re: MV-72 flashing blue light on boot.

Try to perform a full factory reset on the device and report back.

https://documentation.meraki.com/zGeneral_Administration/Support/Resetting_Cisco_Meraki_Devices_to_F...
Nolan Herring | nolanwifi.com
TwitterLinkedIn
Kind of a big deal

Re: MV-72 flashing blue light on boot.

If you plug a notebook into the same cable does it work?

Conversationalist

Re: MV-72 flashing blue light on boot.

yes

 

Kind of a big deal

Re: MV-72 flashing blue light on boot.

Have you got a PoE switch or a different PoE injector you can test with?

 

I assume the overall cable run is less than 100m including patch leads?

 

I'm thinking two potential issues:

* problem with PoE injector

* problem with cabling, such as attenuation is too high

Conversationalist

Re: MV-72 flashing blue light on boot.

I am going to test the camera on another network with a known good switch and a good cable, I will update tomorrow. Thanks for the input.

Conversationalist

Re: MV-72 flashing blue light on boot.

It was actually the cable that came from Meraki with the camera that was bad. I have never seen that before. Thanks for everyone’s help!!

Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.