MV-72 flashing blue light on boot.

Bernarmn
Conversationalist

MV-72 flashing blue light on boot.

Hello;

 I have a MV-72 that I am trying to install with an 802.3AT POE injector. For some reason, the MV boots into a blue flashing light, which according to the installation manual says it is looking for a wireless connection. I tried it into different ports on the switch it is connected to (also other cameras are connected), but no luck.

 

Any Ideas?  Thanks in advance

 

 

6 REPLIES 6
NolanHerring
Kind of a big deal

Try to perform a full factory reset on the device and report back.

https://documentation.meraki.com/zGeneral_Administration/Support/Resetting_Cisco_Meraki_Devices_to_F...
Nolan Herring | nolanwifi.com
TwitterLinkedIn
PhilipDAth
Kind of a big deal
Kind of a big deal

If you plug a notebook into the same cable does it work?

yes

 

PhilipDAth
Kind of a big deal
Kind of a big deal

Have you got a PoE switch or a different PoE injector you can test with?

 

I assume the overall cable run is less than 100m including patch leads?

 

I'm thinking two potential issues:

* problem with PoE injector

* problem with cabling, such as attenuation is too high

I am going to test the camera on another network with a known good switch and a good cable, I will update tomorrow. Thanks for the input.

It was actually the cable that came from Meraki with the camera that was bad. I have never seen that before. Thanks for everyone’s help!!

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.