In the past couple of weeks we have noticed that the cameras are taking much longer than usual to load. Normally they will take a few seconds, not it can be 30+ seconds to load and sometimes a page refresh is necessary. We have Meraki end-to-end (Camera to Firewall) and haven't made any changes. This happens both on-site (even on the same switch as the camera) and off-site. This seems like it's new to v4 but I cannot be 100% sure of that.
Any thoughts or suggestions? It's both on MV21 and MV71 models.
It says it's on version 4.0 and up to date. It's will all of my cameras not just a specific one or a specific network.
I can try and reset on but most of them are going to require a lift to get to and that is not practical for as many cameras as we have.
4.3 does mention a fix for streaming issues with MV71/21 so I am upgrading a few of them now.
Should be quick to see if that is the fix or not.