Blink Camera system won't connect to Blink Servers

[GeeRod13]

The sync 2 will not communicate to the Blink servers through my current MX110 settings.  The unit works flawlessly when not on my Meraki network.  I am sure the firewall, content filtering, and protection settings are the cause but I cannot and do not know what to look at and change.

The BLink communicates to AWS servers in the US.  I have the majority of countries outside the USA blocked.

[alemabrahao]

Here you will find everything you need.

https://documentation.meraki.com/MX/Firewall_and_Traffic_Shaping/MX_Firewall_Settings

https://documentation.meraki.com/MX/Content_Filtering_and_Threat_Protection/Content_Filtering

https://documentation.meraki.com/General_Administration/Cross-Platform_Content/Meraki_Event_Log

[ww]

You could whitelist the blink device > reconnect the blink device. Then it bypasses firewall and amp. (Not ips)

If it still not works then its probably  the ips (it should show up in the security center/event log)

If you have traffic analysis on detailed, then you can find to where it connects to.

[GreenMan]

I'd be tempted to run some packet captures on the LAN interface too, filtered for the camera's MAC (or IP, if it's a hop away) to see exactly what traffic is generated.   You can then potentially compare the same to what you see on the WAN port

https://documentation.meraki.com/General_Administration/Cross-Platform_Content/Packet_Capture_Overvi...