cancel
Showing results for 
Search instead for 
Did you mean: 

Wrong information shown in client-page, after FW update

SOLVED
Building a reputation

Wrong information shown in client-page, after FW update

Hi all,

 

wondering if someone else has got the same problem... Very bad for our helpdesk... Also opened an case at meraki support, but would like to know if you have the same.

 

For testing, I updated 4 sites yesterday to the newest stable Firmwareversion (MX 13.36 - MX65)

 

Since then, all of them are showing within the Client page:

  • no IP
  • wrong VLAN
  • wrong usage

If I use the Tools-tab and check the arp-table, then it´s shown correctly.

 

 

Clientpage:

Clientpage.png

 

ARP-Table:

Arp table.png

1 ACCEPTED SOLUTION

Accepted Solutions
Building a reputation

Re: Wrong information shown in client-page, after FW update

OK, got it....

 

It is not showing any information, until traffic has been caused from the devices (none nativ vlan devices! Native vlan devices are shown correctly all the time)

Now, since this happened, everything is shown correctly, but only, back to the time when the update has been done.

1 REPLY 1
Building a reputation

Re: Wrong information shown in client-page, after FW update

OK, got it....

 

It is not showing any information, until traffic has been caused from the devices (none nativ vlan devices! Native vlan devices are shown correctly all the time)

Now, since this happened, everything is shown correctly, but only, back to the time when the update has been done.

Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.