Third Party Site to site VPN

Sajid
Here to help

Third Party Site to site VPN

 

 

Hi all,

 

I am trying to create Site to Site VPN where one site is having MX64W and another site is having Check Point R77.30 virtual instance.

 

When i go on dashboard Security appliance > Configure > Site-to-site VPN > Non-Meraki VPN Peers,

 

here Non-Meraki VPN Peer is not showing under Site-to-site VPN Tab.

 

Please suggest a solution.

3 Replies 3
ww
Kind of a big deal
Kind of a big deal

did you select type: hub or spoke

Adam
Kind of a big deal

@ww is correct.  Set your MX up as a Hub or Spoke then you should see the 'Non-Meraki VPN Peers' option at the bottom of the page under Security Appliance>Site-to-Site VPN

Adam R MS | CISSP, CISM, VCP, MCITP, CCNP, ITILv3, CMNO
If this was helpful click the Kudo button below
If my reply solved your issue, please mark it as a solution.
Doke
Here to help

Btw good luck if you need to do some NATing on your side with that non Meraki peer, I hope you have better luck than I did.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels