Mar 24 2023
4:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24 2023
4:05 AM
Syslog : Name of the rule ? And log traffic without rule checked.
Hello,
We're trying to get network log. We would like to know to see what rules block traffic. We install a syslog and nothing. Nor more information.
So we decide to uncheck all "syslog" box on the L3 firewall. And we keep receiving log.
Any help ?
Best regards,
5 Replies 5
Mar 24 2023
4:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24 2023
4:24 AM
You need to select flows at the syslog settings. Then you get all flows. And additional all the firewall logs from the rule you enabled for logging
Mar 24 2023
4:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24 2023
4:25 AM
I don't understand what you want, do you want to receive messages via syslog or not?
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
Please, if this post was useful, leave your kudos and mark it as solved.
Mar 24 2023
4:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24 2023
4:58 AM
I want to receive log from a specific rule.
Mar 24 2023
5:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24 2023
5:02 AM
Have you checked if there is any Hit count?
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
Please, if this post was useful, leave your kudos and mark it as solved.
Mar 24 2023
5:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24 2023
5:38 AM
We found the issue, when we turn on one rule, we have to filter.
Like "tail -f message | grep firewall" otherwise we've a lot of useless "flow" logs.

Get notified when there are additional replies to this discussion.