Site-to-site VPN - Cisco ASA & Cisco Meraki MX250

[Shadius]

Hey all,

I am trying to set up a site-to-site VPN between two sites, our data center and one of our offices. The data center is using a Cisco ASA and the office is using an MX250. The office also has a Cisco 2811 router that we use for our WAN connectivity.

The VPN has been configured on the Cisco ASA and in Meraki, but we're not able to access our shared drives, and can't ping from the data center to the office.

How can I set up this site-to-site VPN between the data center and the office so that our network resources are accessible?

[MarcP]

Have a look into these documents, maybe you missed something?

https://documentation.meraki.com/MX/Site-to-site_VPN/MX_to_Cisco_ASA_Site-to-site_VPN_Setup

https://documentation.meraki.com/MX/Site-to-site_VPN/Site-to-Site_VPN_Settings

Maybe you can share some details on how you set up the VPN on Meraki site. be sure you correctly set the private subnets and ike version on both sites.

[Shadius]

@MarcP 

From the Meraki Dashboard, I have the Public IP address of our data center and the Remote ID matched as the same IP addresses. IKEv1 is set. The private subnets are two subnets we have at the data center. The pre-shared key has been entered.

Here's a screenshot of the IPsec policies: