Setting up PPPoE on MX64, ADSL connection that uses Multiplex VPI and VCI values

SOLVED
Miyagi
Conversationalist

Setting up PPPoE on MX64, ADSL connection that uses Multiplex VPI and VCI values

Hello,

 

I am replacing a Netgear router with a MX64. The ADSL connection setup on the router uses the Multiplex method and uses VPI and VCI values together with username and password of course, Is it even possible to configure the MX with VPI/VCI values for PPPoE adsl connection?

 

I know how to setup PPPoE on MX, the question is only regarding the VPI/VCI values for this certain connection.

 

Thank you.

Miyagi.

 

1 ACCEPTED SOLUTION
PhilipDAth
Kind of a big deal
Kind of a big deal

No.  You would have to bridge the PPPoE frames to the Ethernet port of the DSL router. 

View solution in original post

5 REPLIES 5
PhilipDAth
Kind of a big deal
Kind of a big deal

No.  You would have to bridge the PPPoE frames to the Ethernet port of the DSL router. 

Miyagi
Conversationalist

Hi,

 

Thanks for the quick response.

 

 

You may disable NAT, if required.

It appears that Bridge mode is only applicable if (multicast) IPTV is accessed.

Robin St.Clair | Principal, Caithness Analytics | @uberseehandel
Uberseehandel
Kind of a big deal

What modem are you using?

Robin St.Clair | Principal, Caithness Analytics | @uberseehandel

Hello,

 

It is a Netgear D6400. 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels