Problem reaching a Local Loop VPN target

SY2
Comes here often

Problem reaching a Local Loop VPN target

My network is as per the diagram below. I intend to replace the LAN Gateway with the Meraki MX64. I configured the same IP's on the new Meraki.

The Internet is properly reached while I cannot reach the Local Loop MPLS VPN target (Branch 2) !!!! knowing that I did not configure any kind of VPN's on the Meraki device.

 

SY2_0-1612874078630.png

 

4 Replies 4
ww
Kind of a big deal
Kind of a big deal

Does branch2 knows the route to 10.10.10.2?

SY2
Comes here often

No
Both ways are not working
I guess it can't work one way.

PhilipDAth
Kind of a big deal
Kind of a big deal

I don't see the point in the 10.10.10.1 router.

 

Plug the branch2 MPLS circuit directly into the MX on a VLAN interface, and the ADSL router into the MX WAN interface.

SY2
Comes here often

It is supplied by the service provided preconfigured for the MPLS. Can't be removed....

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels