Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About SY2
SY2
Comes here often
Member since Feb 9, 2021
Jun 11 2023
Community Record
9
Posts
0
Kudos
0
Solutions
Badges
May 16 2023
12:37 AM
I have WAN1 connected to another Cisco router which is responsible for routing the requests received between an Internet source and MPLS VPN. The problem arises when the Internet source on the Cisco router (connected to the Meraki WAN 1) is down while the MPLS VPN is working fine. The Meraki switches all traffic (including VPN) to the backup WAN 2 and consequently losing the VPN connectivity. Can this be solved one way or another?
... View more
May 16 2023
12:11 AM
I have WAN1 connected to another Cisco router which is responsible for routing the requests received between an Internet source and MPLS VPN. The problem arises when the Internet source on the Cisco router (connected to the Meraki WAN 1) is down while the MPLS VPN is working fine. The Meraki switches all traffic (including VPN) to the backup WAN 2 and consequently losing the VPN connectivity.
... View more
May 15 2023
6:36 AM
How to enforce specific subnet requests to be executed on a specific WAN port that does not have Internet service on it? N.B. A WAN port that does not have Internet Service is considered an inactive port and the MX does not forward any requests to it even if the Traffic shaping rule is requesting so.
... View more
Feb 16 2021
12:17 AM
The support replied that I should install a beta firmware version so they can enable the NO NAT feature on it. I do have the latest version 15.42. How can I obtain a beta version to replace the 15.42.
... View more
Feb 15 2021
2:58 AM
Is there a way to disable any NATing rules defined on the MX64, is this possible?
... View more
Feb 9 2021
11:11 PM
It is supplied by the service provided preconfigured for the MPLS. Can't be removed....
... View more
Feb 9 2021
4:34 AM
My network is as per the diagram below. I intend to replace the LAN Gateway with the Meraki MX64. I configured the same IP's on the new Meraki. The Internet is properly reached while I cannot reach the Local Loop MPLS VPN target (Branch 2) !!!! knowing that I did not configure any kind of VPN's on the Meraki device.
... View more
© 2024 Cisco Systems, Inc.
