Migrate from MX100 to MX250

Solved
Looker44
Here to help

Migrate from MX100 to MX250

Anyway to clone my existing MX 100 configuration to my new MX250?  Steps? is there a FAQ?

1 Accepted Solution
Ryan_Miles
Meraki Employee
Meraki Employee

https://documentation.meraki.com/MX/Other_Topics/MX_Cold_Swap_Replacing_an_Existing_MX_with_a_Differ...

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

View solution in original post

7 Replies 7
Ryan_Miles
Meraki Employee
Meraki Employee

https://documentation.meraki.com/MX/Other_Topics/MX_Cold_Swap_Replacing_an_Existing_MX_with_a_Differ...

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
CptnCrnch
Kind of a big deal
Kind of a big deal

Of course there is one 😉 Meraki docs are great!

https://documentation.meraki.com/MX/Other_Topics/MX_Cold_Swap_Replacing_an_Existing_MX_with_a_Differ...

 

(Oops, too late...)

Inderdeep
Kind of a big deal
Kind of a big deal

@CptnCrnch : not to late but kudos from my side 🙂

Regards/Inder
Cisco IT Blogs awarded in 2020 & 2021
www.thenetworkdna.com
Looker44
Here to help

thanks gents. I saw that one, just wanted verification!!!

Brogan
Comes here often

I have walked this road and it wasn't pleasant or as simple as the documentation suggests. It took approximately 3-4 MX 250 RMA's, waiting on new firmware and bug fixes and about 2-3 years before we were able to successfully swap MX100 with MX250.

 

I think it was in firmware MX15.x that it was mostly sorted and we were able to replace mx100 with mx250 but yeah for us it was painful process. 

 

Best of luck     

Looker44
Here to help

well this sounds fun!

managenet
New here

Hi All, 

 

I have read through the doc:

https://documentation.meraki.com/MX/Other_Topics/MX_Cold_Swap_Replacing_an_Existing_MX_with_a_Differ...

 

Two quick questions regarding Quick Swap, Method 1 please:

 

1) Under the section: Remove the Old MX from the Current Network...

There appear to be an omission in that it says 'To remove an MX from an existing network, follow the steps below.' and then has no steps below, only a warning note regarding unique client identifier, (not an issue in my use case).  I am assuming the missing steps are just the 'Remove appliance from network...' button under Monitor->Appliance Status.  Correct?

 

2) I am assuming the step after completing Add the Replacement MX to the Same Network

 and previous to physically connection the new replacement MX: Adding a Second MX to Form a Warm Spare Configuration should be marked 'Optional', as in our case we are not adding a pair of MXs?  Or, is it in fact necessary to add the new, single replacement MX250 as a Warm Spare in order to get the configuration?  I would assume that this step is not applicable, and that rather, after completing Add the Replacement MX to the Same Network, the new MX is available for monitoring and configuration and will configure upon physical WAN connection.  Correct?

 

Thank you in advance!

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels