Meraki MX and Azure VPN gateway in a route-based mode

[Synnapex]

Hello,

I know there were several topics about Azure-Meraki VPN tunnels...but here is another one.

I have a client with Azure VPN Gateway in route-based mode, and, as I understood so far, there is no "out-of-the-box" solution to establish a VPN tunnel to Meraki MX.

I'm wondering if Meraki Support will activate IKEv2, will I be able to connect to Azure VPN gateway configured in a  Route-base mode?

Is there any solution to this situation at all?

[ChrisC83 · Accepted solution]

Hi,

I believe Meraki with IKEv2 will work with route-based GW on Azure.

You will need to upgrade your MX to firmware 15.x and call support to enable the IKEv2 on the specific tunnel.

[Synnapex]

Thank you, ChrisC83,

We will try that and I will update the topic after.

[Synnapex]

Update: by enabling IKEv2, Azure routed VPN started to work

[Jeizzen]

Hi,

As of may 2020, I was able to create a connected vpn with Azure that worked by configuring this way :

Azure : routed-based vpn IKEv1

Meraki : Azure preset, but deleting the MD5 in phase 2