MX68 to L2 HP 2530 Switch

[ewolf]

Hello,

I am in the process of switching over from an ASA5506 to the MX68.  When I switched over the MX68, I trunked port 3 on the MX68.  This port goes to a L2 HP switch.  The connecting port was tagged for both VLANs, 99 and 100.  No devices on VLAN 100 were able to get to the Internet or receive DHCP from the MX68, but devices connected to my Cisco AP and on VLAN 99 was getting DHCP and to the Internet.  Port 3 on the MX68 goes to Port 25 on the Hp Switch.   Am I missing something? Here are the configs:

HP2530:

vlan 1

name "DEFAULT_VLAN"

no untagged 1-23

untagged 25-28

tagged 24

no ip address

exit

vlan 99

name "ReindersGuest"

tagged 22-23

no ip address

exit

vlan 100

name "Users"

untagged 1-23

tagged 25

ip address 10.1.4.10 255.255.255.0

exit

primary-vlan 100

[kYutobi]

Did you add the DHCP relay? Where is your DHCP server being provided?

[ewolf]

The MX68 is providing the DHCP.

[Raj66 · Accepted solution]

@ewolf You configured port 3 on the MX68 as trunk port with native vlan 100. Does the native vlan match on the HP switch? In HP terminology, vlan 100 should be untagged on the port where the MX68 is connected.  Also, Are you running DHCP server on the MX68? If not, you might want to configure an IP-Helper for the DHCP server, Make sure you have that config in place. 

Cheers!

Raj

[ewolf]

That makes sense now. I will untag port 25 for vlan 100 on the HP switch to make it the native vlan on that port.