cancel
Showing results for 
Search instead for 
Did you mean: 

MX64 dropping wired clients

Here to help

MX64 dropping wired clients

Hello all,

 

I have a few networks with only an MX64 where the wired clients simply lose connection. While looking at my network connections (Windows PC) i can see the status change to "network cable unplugged" from time to time with no rhyme or reason.

 

Anyone else see this?

3 REPLIES 3
Kind of a big deal

Re: MX64 dropping wired clients

The clients are connected directly to the MX or to a downstream switch?

Adam R MS | CISSP, CISM, VCP, MCITP, CCNP, ITILv3, CMNO
If this was helpful click the Kudo button below
If my reply solved your issue, please mark it as a solution.
Here to help

Re: MX64 dropping wired clients

These are wired directly to the firewall.  This does not seem to occur if a switch is in line.

Kind of a big deal

Re: MX64 dropping wired clients

I think I would start with the firmware.

 

If you are using the 13.x train then go for 13.33 (under stable release candidates).

If you are using the 14.x train then go for 14.25.

Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.