MX100 displays security appliance details...

[jb61264]

When I use my phone to type in the IP address of our Meraki's public IP address, it is showing a "Security Appliance Details" under the "Connection" tab...none of the other tabs (Configure, Ethernet, Cellular Status) show any information thankfully...why would the "Connection" tab display this information without even being logged in???? and more importantly, how can I configure it to not show this information?

[AMP · Accepted solution]

Hello,

You can control this by following this documentation:
https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Me...

[PhilipDAth]

It normally only shows this if you browse to it from inside of the MX, unless you have enabled "Layer 3 Inbound Rules" and not created a rule to block it.