MX100 changing ISP

Solved
Rayw
Here to help

MX100 changing ISP

I have an MX100 and am changing ISP so I will have a new set of public IPs.  Is there a way I can configure all these changes to NAT rules and WAN interface a head of time to and then apply the changes to make the cut  over faster rather than at time of cutover doing all the config changes then?

 

1 Accepted Solution
PhilipDAth
Kind of a big deal
Kind of a big deal

Great answer by @ww .

 

Another option with regard to the NAT rules - just add them now.  They are only NAT rules so have no idea whether the address is correct or not.  They just won't do anything until you configure the WAN interface with the new addressing.

View solution in original post

2 Replies 2
ww
Kind of a big deal
Kind of a big deal

You can use the 2nd wan port

 

When you are done, set the primary interface to wan2

https://documentation.meraki.com/MX/Firewall_and_Traffic_Shaping/MX_Load_Balancing_and_Flow_Preferen...

PhilipDAth
Kind of a big deal
Kind of a big deal

Great answer by @ww .

 

Another option with regard to the NAT rules - just add them now.  They are only NAT rules so have no idea whether the address is correct or not.  They just won't do anything until you configure the WAN interface with the new addressing.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels