MX Firmware 19.2.1

Holli69
Building a reputation

MX Firmware 19.2.1

Hello,

 

Has someone tried the latest beta 19.2.1 with a non-Meraki VPN peer and DH21 group?

I installed the FW on one VPN Concentrator where approximately 30 branch offices terminate, all with non-Meraki VPN.

I observe some instability because 20-30 percent of all VPN's show as offline, some show online after a few hours, but then others are shown as offline (before they were online)

BTW: the VPN Concentrator is an MX450.

 

3 Replies 3
PhilipDAth
Kind of a big deal
Kind of a big deal

I haven't tested IPSec myself, but I have found that 19.2.1 makes MX95s crash and reboot regularly.

Ryan_Miles
Meraki Employee All-Star Meraki Employee All-Star
Meraki Employee All-Star

Wonder if it's config or load specific. I updated my MX95 the day it was posted and it's run fine since then.

PhilipDAth
Kind of a big deal
Kind of a big deal

The one I have been having a lot of problems with is used as an AnyConnect VPN concentrator and AutoVPN hub.

 

The Summary page indicates the load is low.

Get notified when there are additional replies to this discussion.