MX 450 Install and config

BigK
Here to help

MX 450 Install and config

Hello, 

 

I am new to MX 450 install and config. I am tasked with install of 450 mx at the data center. 

My plan is to

1 - connect a laptop to management port and brows to the setup url.

2- Enter the WAN IP address

3- The MX will be connected to a switch 

4 - Wan 1 will be configured as dynamic to receive dhcp from dhcp server

5- Enter the DNS config

 

New network is already crated on dashboard as well as the enterprise key and read the installation Guide here.

MS450 Series Installation Guide - Cisco Meraki

 

Any other tutorial or help will be appreciated.

 

Thanks

 

 

I think with that I should be enough to access the MX remotely and continue with the installation and configuration 

1 Reply 1
alemabrahao
Kind of a big deal
Kind of a big deal

It's the correct install guide:

 

https://documentation.meraki.com/MX/MX_Installation_Guides/MX450_Installation_Guide

 

Take a look at these guides:

 

https://documentation.meraki.com/MX/Deployment_Guides

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels