I have a sd-wan solution that has a MX 68w and MR 44   I configured the VPN on the 68W and the VPN status looks Green    VPN Registry: Connected. This WAN appliance is able to connect to multiple VPN registries using UDP port 9350 & 9351. NAT type: Friendly. This WAN appliance is behind a VPN-friendly NAT, locally using 192.168.8.11 :56859, which is NAT-ed to 132.15.4.12.5:14671 Encrypted. Using IPsec and AES encryption.   All SSID on the 68W are disabled.  I connected 2 X MR 44s to POE port and the ports are green When I plugged in the MR 44 new network automatically appeared in the dashboard called wireless  I configured the SSIDs on the MR 44 The MX 68 status shows the ports connected, but the wireless network shows down..      any help is appreciated it    Thanks   ... View more

Hello,    I am new to Meraki SD WAN and need some help from design perspective.  In the DC. I have a MX450 connected to a cisco switch which is connected to a router and out to the internet.   Now I do have a couple of branches that will be using MX68CW.   The goal is to have the 2 branches use SD WAN technology using MX450 in the data center and MX68CW in the branches.    Here is what I know so far by picking at one of the branches and DC config.  MX68CW to MX450 is site to site VPN.  VLANs are configured on MX68CW with their subnets. MX450 Addressing & VLANs = Deployment Settings is Passthrough or VPN Concentrator Site to site VPN on the MX450 --> is Hub (Mesh) Port 1 on the MX450 is connected to internet.  Client tracking is = Ip address any help with the design perspective will appreciate it.   Thanks             ... View more

Hello,   does Meraki MX68CW support T-mobile GSM? I found this link MX67 and MX68 Datasheet - Cisco Meraki and in the datasheet is shows that Tested carriers are:    Tested Carriers ----- > Verizon, AT&T, Bell Canada, T-Mobile, Telus, Rogers   Any other documentation or confirmation is appreciated.   Thanks! ... View more

Hello,    I am new to MX 450 install and config. I am tasked with install of 450 mx at the data center.  My plan is to 1 - connect a laptop to management port and brows to the setup url. 2- Enter the WAN IP address 3- The MX will be connected to a switch  4 - Wan 1 will be configured as dynamic to receive dhcp from dhcp server 5- Enter the DNS config   New network is already crated on dashboard as well as the enterprise key and read the installation Guide here. MS450 Series Installation Guide - Cisco Meraki   Any other tutorial or help will be appreciated.   Thanks     I think with that I should be enough to access the MX remotely and continue with the installation and configuration  ... View more