MG41 and MX

Aamir
Here to help

MG41 and MX

Hi,

 

I have two MX in HA and one MG41, can i connect the single MG41 with both MX (WAN port) and if primary MX fails the secondary MX will take over and go on the internet via MG41? will that work automatically, any special configuration needed to make that happen?

1 Reply 1
Ryan_Miles
Meraki Employee
Meraki Employee

Yes, that works just fine and it's a very typical deployment.

 

https://documentation.meraki.com/MG/MG_Best_Practices/MG_Cellular_Best_Practices#MG_with_HA_Pair

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels