MFA w/ Client VPN

Solved
RGrayTpT
Conversationalist

MFA w/ Client VPN

Is there a way to enable MFA for Cisco VPN?

1 Accepted Solution
alemabrahao
Kind of a big deal
Kind of a big deal

Hi @RGrayTpT,

 

I think that this link can be helpful:

 

https://documentation.meraki.com/MX/Client_VPN/AnyConnect_on_the_MX_Appliance/Authentication

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

3 Replies 3
alemabrahao
Kind of a big deal
Kind of a big deal

Hi @RGrayTpT,

 

I think that this link can be helpful:

 

https://documentation.meraki.com/MX/Client_VPN/AnyConnect_on_the_MX_Appliance/Authentication

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
RomanMD
Building a reputation

It depends about which Client VPN you are talking - IPsec VPN or Anyconnect? 

Meraki doesn't support it natively, but it is possible to integrate with 3rd party authentication solution which will provide another factor auth. (https://documentation.meraki.com/General_Administration/Other_Topics/Two-Factor_Authentication)

 

RGrayTpT
Conversationalist

Thanks! I found a few old forum topics with good suggestions as well.

Get notified when there are additional replies to this discussion.