Local INternet Breakout option

[AlaNaifa]

Hi all,

I am going through this documentation and i was wondering when i can see the option of Local internet breakout under the Security & SD-WAN > SD-WAN and Traffic Shaping.

do i need to have the device in Spoke with Default route first ? because in the page currently i am not finding that option.

VPN Full-Tunnel Exclusion (Application and IP/URL Based Local Internet Breakout) - Cisco Meraki Docu...

[SamerAl · Accepted solution]

Hi AlaNaifa,

Yes that is right ,if you configure the MX as a Spoke and the IPv4 Default Route was checked, the MX would be doing full-tunnel VPN to the hub site, sending 100% of its traffic to the hub, and thus a Local Internet breakout option would be present on the SD-WAN & Traffic Shaping page.

If that is not the case and the MX is not spoke with default route to the hub, the MX will already be doing split-tunnel VPN to the hub and it has Local Internet breakout for anything not behind the hub and thus a Local Internet breakout option on the SD-WAN & Traffic Shaping page is not presented in this case.

[navysubvet]

Is there a way to enter multiple subnets? I seem only to be able to add 1 at a time, and I need to apply at multiple locations. There must be a less tedious way...

[AlaNaifa]

Thank you alot for the reply.

[PhilipDAth]

Note this requirement:

Minimum License Type: Secure SD-WAN Plus or Advance Teleworker

[AlaNaifa]

Hi PhilipDath,

thank you for your input, so the License of Advanced security will not be enough for Local Internet breakout feature,

Kindly if you can share the document that specify this ?

Thanks

[AlaNaifa]

Thanks Again, please ignore my request. i found the minimum license requirement document.

Thanks A alot again, your feedback was really helpful.