Is there a means to increate MX67 max throughput

[MerakiMed]

I have a large copy job and I noticed that maximum throughput is listed at 600Mbps. If I turned off some of the inspection services might it be possible to get closer to the 1Gbps? This is inside to outside traffic flow. Thank you. 

[Brash · Accepted solution]

As per the datasheet, 600mbps is the maximum throughput of the mx67. There's no way to increase it.

https://meraki.cisco.com/product-collateral/mx-family-datasheet/

[alemabrahao]

No way, the maximum throughput is 600Mbps.

[Brash]

As a side note, some people have reported getting higher than the maximum on newer firmware with all security features turned off. Definitely not a validated and expected behaviour though.

https://community.meraki.com/t5/Security-SD-WAN/MX68CW-Maximum-WAN-troughput/m-p/187457#M43900

[MerakiMed]

Thanks for the speedy replies.

[RaphaelL]

If you put the slider to 600 ( which is the MAX ) It might go over 600Mbps. 

If you set it to Maximum-1 , it will actually limit it to Max-1. 

As Brash stated , some users have found that the MX are achieving speed higher than advertised ( as myself ).