Flapping VPN

Jackhigh
New here

Flapping VPN

We have been having and issue with our meraki VPNs.

All remote sites will lose connection at the same time for about 2 minutes then it comes back online.

our main site does not show that it has lost connection on either of the WAN ports during that time 

This is not happening every night but it is happening frequently enough that it is causing issues.

has anyone else experienced this issue?

8 Replies 8
alemabrahao
Kind of a big deal
Kind of a big deal

What version are you running? Take a look on this:

 

alemabrahao_0-1665670916917.png

 

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Jackhigh
New here

Main location is an MX100 running on 17.8

remote 1 is running on a MX100 on 17.8

remote 2 is running on a MX64 on 16.16

Remote 3 is running on a MX64 on 16.16

RaphaelL
Kind of a big deal
Kind of a big deal

Are remote 2-3 flapping more than remote 1 ?

Jackhigh
New here

They are not it's all 3 together at the same time

alemabrahao
Kind of a big deal
Kind of a big deal

Is it possible change all MXes for version 16.16.6? 

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Jackhigh
New here

both MX64's state they are on the latest version

are you suggesting to downgrade both MX 100's to 16.16.6?

alemabrahao
Kind of a big deal
Kind of a big deal

Are the MX64 on version 16.16.6 or 16.16?

 

Yes, I'm suggesting downgrade both, the version 17.8 is not stable.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Pavithran
Here to help

We can uplink statics tracking on SD-WAN traffic shaping.

 

> Add the WAN IP address of remote peers just to make sure that there is no ISP connectivity issue.

> Appliance status -> Uplink section will help us to see if there is any packet loss and latency.

 

We usually see these disconnections because of ISP circuits.

Get notified when there are additional replies to this discussion.