Configuring physical link settings MX65

[pcrequest]

Where do I find the MX65 controls to verify link Autonegotiate/duplex/speed etc?  I found a guide but I can't find the headings they reference, so perhaps outdated?  https://www.libble.eu/cisco-meraki-mx65/online-manual-922666/?page=6

Here's what's going on: the Internet works, but the link is slower than our service level.  I have Internet 2 showing 100Mbps full duplex when I hover over the Summary tab graphic (Security & SD-WAN > Appliance status > Summary).  It has Cat 5e patch from Internet 2 to the ISP's ONT which the ISP says should auto-negotiate at 1Gbps (and that's the speed we pay for).  Internet 1 port is open and can be used for troubleshooting.  My next opportunity I'll have someone onsite try WAN1.  

Thanks

[KarstenI · Accepted solution]

Speed/Duplex settings are configured on the Local status page:

https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Me...

AutoNeg is the default, but the MX65 is by far too slow for a 1Gig ISP link. This device has a rating of 250 MBit/s maximum.

[pcrequest]

It wasn't clicking for me what the Local page was.  I rarely get to touch see or touch the hardware.  So I'll need to remote into a laptop into the site to reach the Local page.  Thanks.