Configuring Inbound Rules for Specific Traffic in Meraki with IP Range and Port Range

[HSHan]

I am experiencing difficulty adding an inbound rule to allow specific traffic from the IP range 168.86.128.0/18 and ports 10000 to 60000. However, it seems that Meraki only allows options for "Any," "IPv6," and "VLAN." Can anyone provide advice or a solution for this situation?

[ww · Accepted solution]

Look at the top left. That are ipv6 inbound rules.

I think ipv4 inbound rules only work on request at meraki support.

With ipv4 nat mode you can allow ipv4 traffic in using port forwarding/nat rules

[HSHan]

I see that I am referring to IPv6 rules. Thank you. Do you happen to have any references or information regarding IPv4 traffic for port forwarding or NAT?

[ww]

https://documentation.meraki.com/MX/NAT_and_Port_Forwarding/Port_Forwarding_and_NAT_Rules_on_the_MX#...