Meraki

WarrenG · ‎Nov 28 2022

We successfully implemented Azure AD authentication for AnyConnect and have been using it successfully. We just upgraded our MX67 firmware from version 16.16 to version 17.10.2 and now all of a sudden when we try to connect it prompts us to type in the full email address and password each time. The computer does not remember anything, and every time it is asking for us to type in the full credentials. Is there a way to get it to remember the last logged in user so that we do not have to type in our email address every time?

alemabrahao · ‎Nov 28 2022

I suggest you to downgrade to version 16.16.7 and open a case.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Ryan_Miles · ‎Nov 28 2022

It's this issue https://community.meraki.com/t5/Security-SD-WAN/AnyConnect-w-SAML-amp-Azure-AD-Authentication-not-pr...

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

WarrenG · ‎Nov 28 2022

Thanks Ryan. I don't see a solution there though. How do we fix this to work the way it did before?

Ryan_Miles · ‎Nov 28 2022

It's mentioned in the thread. You need to open a Support case for the backend config option to be set.

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

WarrenG · ‎Nov 28 2022

So it is. Thanks.

Meraki

Community

AnyConnect + Azure AD Authentication

AnyConnect + Azure AD Authentication