Meraki GR10 mesh problem on 2.4 GHz


Meraki GR10 mesh problem on 2.4 GHz



I have two SSIDs: one for 5 GHz and one for 2.4GHz.

I have a gateway AP which works fine for both of them.

I have a mesh AP where the 5 GHz SSID works, but on the 2.4 GHz I have IP but can't reach the internet.

The firmwares are up to date.


Do you have any idea?




1 Reply 1
Meraki Alumni (Retired)
Meraki Alumni (Retired)

Hi @fkuris 


Its time to figure out where the breakage occurs. We know you have an IP in this situation you have described, so lets find out where access cuts out:

  • Can you access the GR local status page you are directly connected to?
    • Navigate to the IP address of the GR in your phones/mobile devices browser.
    • Navigate to - using DNS instead of an IP. Does this work?
      • If this failed, DNS is not working. Perhaps due to packet loss.
  • Can you ping anything in a command prompt like ping Might need a laptop for this test.

There could be various causes to this behavior, and I'm suspecting high interference on 2.4 Ghz just for this access point's location.

Get notified when there are additional replies to this discussion.